| 1. |
- Aad, G, et al.
(författare)
-
Performance of the upgraded PreProcessor of the ATLAS Level-1 Calorimeter Trigger
- 2020
-
Ingår i: Journal of Instrumentation. - : IOP Publishing. - 1748-0221. ; 15:11
-
Tidskriftsartikel (refereegranskat)abstract
- The PreProcessor of the ATLAS Level-1 Calorimeter Trigger prepares the analogue trigger signals sent from the ATLAS calorimeters by digitising, synchronising, and calibrating them to reconstruct transverse energy deposits, which are then used in further processing to identify event features. During the first long shutdown of the LHC from 2013 to 2014, the central components of the PreProcessor, the Multichip Modules, were replaced by upgraded versions that feature modern ADC and FPGA technology to ensure optimal performance in the high pile-up environment of LHC Run 2. This paper describes the features of the new Multichip Modules along with the improvements to the signal processing achieved. c 2020 CERN for the benefit of the ATLAS collaboration. Published by IOP Publishing Ltd on behalf of Sissa Medialab.
|
|
| 2. |
- Aad, G, et al.
(författare)
-
Resolution of the ATLAS muon spectrometer monitored drift tubes in LHC Run 2
- 2019
-
Ingår i: Journal of Instrumentation. - : IOP PUBLISHING LTD. - 1748-0221. ; 14:9
-
Tidskriftsartikel (refereegranskat)abstract
- The momentum measurement capability of the ATLAS muon spectrometer relies fundamentally on the intrinsic single-hit spatial resolution of the monitored drift tube precision tracking chambers. Optimal resolution is achieved with a dedicated calibration program that addresses the specific operating conditions of the 354 000 high-pressure drift tubes in the spectrometer. The calibrations consist of a set of timing offsets and drift time to drift distance transfer relations, and result in chamber resolution functions. This paper describes novel algorithms to obtain precision calibrations from data collected by ATLAS in LHC Run 2 and from a gas monitoring chamber, deployed in a dedicated gas facility. The algorithm output consists of a pair of correction constants per chamber which are applied to baseline calibrations, and determined to be valid for the entire ATLAS Run 2. The final single-hit spatial resolution, averaged over 1172 monitored drift tube chambers, is 81.7 ± 2.2 μm. © 2019 CERN for the benefit of the ATLAS collaboration. Published by IOP Publishing Ltd on behalf of Sissa Medialab. Original content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.
|
|
| 3. |
- Andrean, Stefio Y., et al.
(författare)
-
Measurements of sensor radiation damage in the ATLAS inner detector using leakage currents
- 2021
-
Ingår i: Journal of Instrumentation. - : IOP Publishing Ltd. - 1748-0221 .- 1748-0221. ; 16:8
-
Tidskriftsartikel (refereegranskat)abstract
- Non-ionizing energy loss causes bulk damage to the silicon sensors of the ATLAS pixel and strip detectors. This damage has important implications for data-taking operations, charged-particle track reconstruction, detector simulations, and physics analysis. This paper presents simulations and measurements of the leakage current in the ATLAS pixel detector and semiconductor tracker as a function of location in the detector and time, using data collected in Run 1 (2010–2012) and Run 2 (2015–2018) of the Large Hadron Collider. The extracted fluence shows a much stronger |z|-dependence in the innermost layers than is seen in simulation. Furthermore, the overall fluence on the second innermost layer is significantly higher than in simulation, with better agreement in layers at higher radii. These measurements are important for validating the simulation models and can be used in part to justify safety factors for future detector designs and interventions.
|
|
| 4. |
- Andrean, Stefio Y., et al.
(författare)
-
Operation of the ATLAS trigger system in Run 2
- 2020
-
Ingår i: Journal of Instrumentation. - : IOP Publishing. - 1748-0221 .- 1748-0221. ; 15:10
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS experiment at the Large Hadron Collider employs a two-level trigger system to record data at an average rate of 1 kHz from physics collisions, starting from an initial bunch crossing rate of 40 MHz. During the LHC Run 2 (2015-2018), the ATLAS trigger system operated successfully with excellent performance and flexibility by adapting to the various run conditions encountered and has been vital for the ATLAS Run-2 physics programme For proton-proton running, approximately 1500 individual event selections were included in a trigger menu which specified the physics signatures and selection algorithms used for the data-taking, and the allocated event rate and bandwidth. The trigger menu must reflect the physics goals for a given data collection period, taking into account the instantaneous luminosity of the LHC and limitations from the ATLAS detector readout, online processing farm, and offline storage. This document discusses the operation of the ATLAS trigger system during the nominal proton-proton data collection in Run 2 with examples of special data-taking runs. Aspects of software validation, evolution of the trigger selection algorithms during Run 2, monitoring of the trigger system and data quality as well as trigger configuration are presented.
|
|
| 5. |
- Andrean, Stefio Y., 1991-, et al.
(författare)
-
The ATLAS Fast TracKer system
- 2021
-
Ingår i: Journal of Instrumentation. - : Institute of Physics Publishing (IOPP). - 1748-0221 .- 1748-0221. ; 16:7
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS Fast TracKer (FTK) was designed to provide full tracking for the ATLAS high-level trigger by using pattern recognition based on Associative Memory (AM) chips and fitting in high-speed field programmable gate arrays. The tracks found by the FTK are based on inputs from all modules of the pixel and silicon microstrip trackers. The as-built FTK system and components are described, as is the online software used to control them while running in the ATLAS data acquisition system. Also described is the simulation of the FTK hardware and the optimization of the AM pattern banks. An optimization for long-lived particles with large impact parameter values is included. A test of the FTK system with the data playback facility that allowed the FTK to be commissioned during the shutdown between Run 2 and Run 3 of the LHC is reported. The resulting tracks from part of the FTK system covering a limited eta-phi region of the detector are compared with the output from the FTK simulation. It is shown that FTK performance is in good agreement with the simulation.
|
|
| 6. |
- G., Aad, et al.
(författare)
-
Electron and photon performance measurements with the ATLAS detector using the 2015-2017 LHC proton-proton collision data
- 2019
-
Ingår i: Journal of Instrumentation. - : IOP PUBLISHING LTD. - 1748-0221. ; 14:12
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the reconstruction of electrons and photons with the ATLAS detector, employed for measurements and searches exploiting the complete LHC Run 2 dataset. An improved energy clustering algorithm is introduced, and its implications for the measurement and identification of prompt electrons and photons are discussed in detail. Corrections and calibrations that affect performance, including energy calibration, identification and isolation efficiencies, and the measurement of the charge of reconstructed electron candidates are determined using up to 81 fb-1 of proton-proton collision data collected at √s = 13 TeV between 2015 and 2017. © 2019 CERN for the benefit of the ATLAS collaboration. Published by IOP Publishing Ltd on behalf of Sissa Medialab.
|
|
| 7. |
- Milstead, David A., et al.
(författare)
-
Comparison between simulated and observed LHC beam backgrounds in the ATLAS experiment at Ebeam=4 TeV
- 2018
-
Ingår i: Journal of Instrumentation. - : Institute of Physics Publishing (IOPP). - 1748-0221. ; 13:12
-
Tidskriftsartikel (refereegranskat)abstract
- Results of dedicated Monte Carlo simulations of beam-induced background (BIB) in the ATLAS experiment at the Large Hadron Collider (LHC) are presented and compared with data recorded in 2012. During normal physics operation this background arises mainly from scattering of the 4 TeV protons on residual gas in the beam pipe. Methods of reconstructing the BIB signals in the ATLAS detector, developed and implemented in the simulation chain based on the \textsc{Fluka} Monte Carlo simulation package, are described. The interaction rates are determined from the residual gas pressure distribution in the LHC ring in order to set an absolute scale on the predicted rates of BIB so that they can be compared quantitatively with data. Through these comparisons the origins of the BIB leading to different observables in the ATLAS detectors are analysed. The level of agreement between simulation results and BIB measurements by ATLAS in 2012 demonstrates that a good understanding of the origin of BIB has been reached. © 2018 CERN for the benefit of the ATLAS collaboration.
|
|
| 8. |
- Milstead, David A., et al.
(författare)
-
Electron and photon energy calibration with the ATLAS detector using 2015-2016 LHC proton-proton collision data
- 2019
-
Ingår i: Journal of Instrumentation. - : Institute of Physics (IOP). - 1748-0221. ; 14:3
-
Tidskriftsartikel (refereegranskat)abstract
- This paper presents the electron and photon energy calibration obtained with the ATLAS detector using about 36 fb -1 of LHC proton-proton collision data recorded at s=13 TeV in 2015 and 2016. The different calibration steps applied to the data and the optimization of the reconstruction of electron and photon energies are discussed. The absolute energy scale is set using a large sample of Z boson decays into electron-positron pairs. The systematic uncertainty in the energy scale calibration varies between 0.03% to 0.2% in most of the detector acceptance for electrons with transverse momentum close to 45 GeV . For electrons with transverse momentum of 10 GeV the typical uncertainty is 0.3% to 0.8% and it varies between 0.25% and 1% for photons with transverse momentum around 60 GeV . Validations of the energy calibration with J/ψ → e + e - decays and radiative Z boson decays are also presented. © 2019 CERN for the benefit of the ATLAS collaboration.
|
|
| 9. |
- Milstead, David A., et al.
(författare)
-
Modelling radiation damage to pixel sensors in the ATLAS detector
- 2019
-
Ingår i: Journal of Instrumentation. - : IOP PUBLISHING LTD. - 1748-0221. ; 14:6
-
Tidskriftsartikel (refereegranskat)abstract
- Silicon pixel detectors are at the core of the current and planned upgrade of the ATLAS experiment at the LHC. Given their close proximity to the interaction point, these detectors will be exposed to an unprecedented amount of radiation over their lifetime. The current pixel detector will receive damage from non-ionizing radiation in excess of 1015 1 MeV neq/cm2, while the pixel detector designed for the high-luminosity LHC must cope with an order of magnitude larger fluence. This paper presents a digitization model incorporating effects of radiation damage to the pixel sensors. The model is described in detail and predictions for the charge collection efficiency and Lorentz angle are compared with collision data collected between 2015 and 2017 (≤ 10 1 MeV neq/cm2). © 2019 CERN for the benefit of the ATLAS collaboration. Published by IOP Publishing Ltd on behalf of Sissa Medialab. Original content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence.
|
|
| 10. |
- Aad, G, et al.
(författare)
-
Measurement of Azimuthal Anisotropy of Muons from Charm and Bottom Hadrons in pp Collisions at s =13 TeV with the ATLAS Detector
- 2020
-
Ingår i: Physical Review Letters. - : AMER PHYSICAL SOC. - 1079-7114 .- 0031-9007. ; 124:8
-
Tidskriftsartikel (refereegranskat)abstract
- The elliptic flow of muons from the decay of charm and bottom hadrons is measured in pp collisions at √s=13 TeV using a data sample with an integrated luminosity of 150 pb-1 recorded by the ATLAS detector at the LHC. The muons from heavy-flavor decay are separated from light-hadron decay muons using momentum imbalance between the tracking and muon spectrometers. The heavy-flavor decay muons are further separated into those from charm decay and those from bottom decay using the distance-of-closest-approach to the collision vertex. The measurement is performed for muons in the transverse momentum range 4-7 GeV and pseudorapidity range |η| < 2.4. A significant nonzero elliptic anisotropy coefficient v2 is observed for muons from charm decays, while the v2 value for muons from bottom decays is consistent with zero within uncertainties.
|
|
